After each use

Use the touchscreen controls to drain ballast tanks. Then, wash and dry the hull with a soft brush and non-abrasive soap. Finally, rinse bilge areas, hull, prop, and components with fresh water before covering.

Monthly

Inspect the bilges for standing water by opening the two inspection hatches, one lives underneath the windshield and the other is inside the transom storage.

Inspect the thrust bearing via the deck hatch for signs of leakage that may indicate early seal failure.

Inspect the propeller shaft seal for signs of leakage. During periods of heavy use, check it daily.

Deep clean the upholstery with a soft bristle brush.

Annually

Inspect the rudder seal, found by opening the floor panel in the transom storage area, for signs of leakage while the boat is in the water.

Periodically clean marine growth from the depth sensorʼs paddlewheel, recommended every 6 months.

View the full Arc Sport owner’s manual here